How to set up small strander?


Small stranding machine is the advancement of modern science and technology, which solves the pain of traditional manual wire processing. It not only has a great improvement in work efficiency, but also has a higher accuracy compared with the success of traditional processing. Many people don't know how to set the stranding machine. Let's have a look at it!

1、 Preparation before stranding

1. Check whether the machine parts are loose.

2. Turn on the power supply and check whether the power indication is normal and whether the machine leaks electricity.

3. Test run the machine and check whether it operates normally and whether there is abnormal sound.

4. Confirm whether the processed wire is consistent with the operation instruction.

3、 Precautions

1. The strander must be operated by trained personnel. The operator shall be familiar with the general performance and structure of the strander, and master the prevention, judgment and emergency treatment measures of equipment failure.

2. When leaving the machine during the production process, the machine shall be suspended to make sure that people leave the machine and stop.

3. During the operation of the machine, the fingers shall not be close to the cutterbed and the collet to prevent injury.

4. In case of any fault, the machine shall be shut down immediately, the circuit shall be short circuited, smoke shall be emitted, and the power shall be cut off in case of leakage. The machine can only be started after the fault is removed, and the equipment shall not operate with fault overload.